Tortello

Product Codes

Armchair

TRT118

Warnings

Keep for reference: read carefully.

Always remember to be careful not to use the product improperly, considering its designated functions.

When the product is no longer used, do not abandon it, but take it to a suitable public waste collection facility.

This product sheet complies with the legal obligations pursuant to the "Consumer Code" Decree n. 206 dated 6/9/2005 and the "Actuation Regulation" Decree n. 101 dated 8/2/1997.

Materials

Upholstery
flexible cold shaped polyurethane foam, polyester fibre cover

Elastic section
thermoplastic elastomer or expanded polyurethane

Frame
polyethylene

Feet cover
nylon

Ferrules
thermoplastic material

Cover
fabric

Maintenance

Cover

For home washing of covers, follow the symbols on the technical sheet that came with the product.
Periodically adjust the Velcro fasteners to remove folds and creases due to normal use of the product.
If there are no Velcro fasteners, smooth the cover manually from the inside towards the outside.
For ordinary cleaning, dust with a soft dry cotton cloth.
If liquids should accidentally fall on the surface, remove them immediately and dry with paper towels.
The surface can then be cleaned with a white cotton or microfibre cloth, slightly damp with water and neutral soap, and then dried in a well-ventilated place.
In case of stains, act immediately to blot the stain with a clean white cloth and, if necessary, remove the dirt with a spoon or knife, using the flat part horizontally and being very careful to not ruin the cover.
Dab the stain from the outer edges inward to avoid rings.
All actions must be done with circular movements, without exerting excessive mechanical pressure.
Our Stores and dealers sell the specific 'Kit for leather maintenance and cleaning' by B&B Italia (code SETPN), which contains products suitable for the protection and cleaning of your leather product.

End of life instructions

Remove the cover and, depending on the composition of the specific fabric, transfer it to the dedicated area. Cut away the following parts and dispose of them in suitable areas: zippers, fasteners and elastic cords.
Remove the upholstered cover and transfer it to a consortium that handles PET disposal. Cut the bottom base and deposit in the correct area.
Remove the polyurethane upholstery and transfer it to a waste-to-energy plant or a PU recovery plant.
Remove the section and transfer it to the plastic materials recovery area.
Remove the frame and transfer it to a consortium that handles polyethylene disposal.
Remove the ferrules and foot covers from the frame and place them in the plastic materials recovery area.

Warranty

B&B Italia guarantees the cover, the feet, the materials, accessories and mechanisms making up the product for 26 months from the date of manufacture (as stated on the "Product data sheet - Guarantee") against any manufacturing defect including lacquering and frame of non-upholstery products. In any case, it has to be pointed out that the materials, even if adequately lightfast to sunlight and artificial light, may be subject to alterations over time due to prolonged exposure to light, washing and ordinary mechanical wear. The guarantee refers to original product manufacturing defects and consists of replacement or repair, free of charge, of the unusable or defective parts, ascertained and acknowledged as such by B&B Italia or its representative. The guarantee does not cover anomalies and spoilage due to:

normal wear over time;
illegitimate use;
inappropriate care with treatments not complying with the enclosed instructions.

Moreover, the guarantee does not cover defects of non-compliance that cannot be attributed to B&B Italia (e.g. incorrect assembling of the product and/or assembling not complying with the assembling instructions). This provision also applies to those products that are designed to be installed directly by the consumer, in the presence of correct and exhaustive instructions. The guarantee shall be forfeited if the products are unassembled, modified or repaired by anyone who is not authorised by B&B Italia. Any intervention made in guarantee does not interrupt the course thereof. To exercise the rights deriving from this guarantee, the relevant "Product data sheet - Guarantee" shall be forwarded to B&B Italia (to the address stated below) bearing the date of manufacture; said "Product data sheet - Guarantee" shall therefore be retained for the entire period during which the guarantee is valid. B&B Italia S.p.A. 22060 Novedrate (CO) Italy, Strada Provinciale 32 n.15 For the purpose of better preserving the product over time it is recommended:

not to jump or sit on the overhanging parts, the backrests and the armrests;
not to drag the product, lifting it instead, so as to avoid damages to the parts resting on the floor;
to protect the product against shocks and contact with pointed and sharp elements and liquids or detergents containing corrosive agents;
to follow the care instructions listed in the specific section of the material enclosed with the product.

Designer

Edward Barber & Jay Osgerby

Edward Barber and Jay Osgerby founded their East London studio in 1996, after studying architecture together at the Royal College of Art. Their approach is characterised by its emphasis on experimentation and innovation and an exploratory attitude to materiality and colour.

From these areas of focus emerge solutions that reflect the close relationship of their work with industrial processes and new technologies, but also its affinities with fine art. The strength of Barber and Osgerby’s creative partnership has led to collaborations with some of the world’s most progressive companies and a diversity of output that encompasses architecture, interiors, sculpture, product and exhibition design. Amongst many professional accolades, Barber and Osgerby received the Jerwood prize in 2004 and in 2007 were awarded the status of “Royal Designers for Industry”. In 2013 they were appointed to the Order of the British Empire, for services to the design industry.

Examples of their work are held in the permanent collections of major museums around the world, such as the Design Museum in London and the Metropolitan Museum of Art in New York, to name a few. In 2001 Barber and Osgerby founded Universal to function in parallel with their primary studio. Focused on the fields of architecture, interiors and exhibition design, Universal is now recognised as one of the world’s most innovative creative design consultancies. In 2012 they launched Map, a strategy-based industrial design consultancy, Map.